Toshiba CS3910BH - Manual (Page 13)

12
D4134051A
5. SPECIFICATIONS
Model CS3910BH
[Electric specification]
Image sensor Interline CCD
Total pixel 1434(H) x 1050(V)
Active pixel 1392(H) x 1040(V)
Unit cell size 6.45(H) x 6.45(V) micrometer m
Optical size Equivalent to 2/3 inch image pickup tube
Scanning system Non-interlace
Aspect ratio 4:3
Sync system Internal / External automatic switchover
Illumination 200 lx (F8 3200K)
Gamma correction Gamma = 1.0(Fixed)
Video output Digital output: EIA-644
Data: 10bit (28.63636MHz)
Scanning frequency 15.29Hz (All pixel data read-out mode) or
60.37Hz (High-speed draft mode)
AGC +/- 6dB
Power source DC12V +/- 10 percent
Power consumption Approximately 2.7W
S/N 50dB(p-p/rms) (Under normal mode)
[Electric shutter specification]
Shutter speed 8 scales from 1/30s through 1/10000s
RTS Random Trigger Shutter
ON/OFF selectable (factory setting: OFF)
Fix mode --- Exposure-time determined by E shutter-speed
Pulse mode --- Exposure-time determined by pulse width
Partial scan ON/OFF selectable (factory setting: OFF)
ON --- Screen center 1/2 readout
Multiple shutter ON/OFF selectable (factory setting: OFF)
Fix mode --- Exposure-time determined by E shutter-speed
Pulse mode --- Exposure-time determined by pulse width
[Internal sync, signal specification]
H drive frequency 28.63636MHz+/-100ppm
Scanning frequency H: 15.998kHz+/-100ppm
V: 15.29Hz+/-100ppm (All pixel data read-out mode)
60.37Hz+/-100ppm (High speed draft read-out mode)
[External sync, signal specification]
External sync signal
HD TTL level, Negative, Input impedance: 10k-ohm
Repeating frequency 15.998kHz +/- 1 %
Pulse width: Longer than 5 micro s
VD TTL level, Negative, Input impedance: 10k-ohm
Repeating frequency 14.98Hz +/- 1 percent
Pulse width: Over 1H(62.5 micro s)