Texas Instruments XIO3130 EVM - Manual (Page 7)

www.ti.com ExpressCard-Mode operation
Figure 1-9. EVM Configuration for ExpressCard Mode
To configure the XIO3130 EVM for ExpressCard-mode operation, the six jumpers (J7, J11, J13, J14, J15,
J16) must be populated (see
Figure 1-5 ). This routes power directly to slots 1 and 2 bypassing the
TPS2363, which is not required for ExpressCard operation.
The dipswitch should be configured with SCL, DN1_DPSTRP, DN2_DPSTRP, and DN3_DPSTRP slide
switches all in the up position. This configuration enables the EEPROM and enables ExpressCard
operation on all three slots. To use two of the PCIe slots in normal-mode operation and one slot for
ExpressCard operation, two of the DNx_DPSTRP slide switches must be in the down position and the
EEPROM needs to be programmed correctly to support this mode of operation. By default, the
ExpressCard mode EEPROM .dat file is set up to enable ExpressCard-mode operation in any of the PCIe
slots that disables the other non-ExpressCard slots from operating in normal mode.
SLLU108 – July 2008 XIO3130 EVM 7
Submit Documentation Feedback