Topcom SMC-2000H - Manual (Page 5)

TOPCOM SMC-2000H 5
TOPCOM SMC-2000H
ENGLISH
4 Installation
4.1 Transportation screw
The massage cushion comes with a screw located on the backside of the unit to protect the massage
mechanism during shipment.
This screw must be removed before use to allow that the massager functions properly.
Properly dispose the screw and install the included black plug into the hole that was left by the screw.
4.2 Strapping system
The massage cushion can be installed to almost an
y chair.
Slip the straps over the seat or chair and
adjust the fastening straps to secure.
The massage won’t slip or slide away.
4.3 Connecting to the main power.
• Plug one end of the power adaptor into the 230V outlet and the other end into the adapter jack
which leads from the massage cushion.
5 Button description
I Power button
• Press the power button to turn the unit on. The corresponding LED
light will illuminate.
• Press the power button once again to turn the unit off. The
massage mechanism will return to its lowest point before
switching off.
II Width adjustment
During rolling massage, you can change the distance between the
massage heads.
With each press on the width button, the massage heads will move to
the next available position.
III Full back rolling massage
Rolling is like two hands or thumbs working up and down along your
spine.
•
Press this button for a full back ‘rolling’ massage.
• The corresponding LED light will illuminate.
• You will enjoy a full back rolling massage
• Press this button again to switch this massage off.
Remove the transportation screw on the backside of the product before use.
Not removing the screw can cause permanent damage to the massage cushion.
No guarantee is accepted in this case.
Only use the power adapter supplied. Do not use other adapters, as this may
damage the device.
The wall outlet for the power supply must be close and accessible.
I
II
III
IV
V
VI
VIII
XII
VII
IX
X
XI