Topcom BABYTALKER 2500 - Manual (Page 6)

6 Topcom Babytalker 2500
Topcom Babytalker 2500
4.5 Link
Do not place the baby unit or cables in the crib or within the arm reach of the baby
(at least 1 meter away).
When using the Babytalker the first time, it is adviced to test the connection.
•
Install the parent unit in the same room as the baby unit, but have at least 1 meter
between the 2 units.
• When both units are switched on, the parent unit will search for the baby unit.
• The green link LED (9) on the parent unit will flash until they communicate.
Once the link is established, the LED will light continuously.
• The voice captured by the microphone will be audible on the parent unit.
• The level of the detected speech is represented by the LED’s on top of the
parent unit (1).
• When the speech reached the maximum level, a beep will be audible.
• When the connection is established, move the parent unit to the monitor room, but within
the operation range.
• When there is no connection, an alert signal (double beep) will be audible (out of range
warning) and the green connection LED will blink.
• Move the parent unit closer until the link is re-established.
4.6 Paging
When your parent unit is lost, you can track it by pressing (18) on the baby unit for
2 seconds.
The parent unit will emit a high beep tone for 30 seconds which helps you to find it very easily.
•
Press on the parent unit (2) briefly to stop the beep.
5 Using the Babytalker 2500
5.1 Volume adjustment
5.1.1 Parent unit
There are 5 volume levels on the parent unit.
•
Press (11) to increase the volume level.
• Press (10) to decrease the volume level.
• When ‘OFF’ is displayed, the babies crying will only be visible by the LED’s on top of the
unit.
5.1.2 Baby unit
• Press (24) to increase the volume level.
• Press (23) to decrease the volume level.
The volume of the babyunit has effect on the talk to baby mode and when the melody is
playing.