Tiger Products Co., Ltd M105X/S - Manual (Page 37)

Assembly Section 2-9
ASSEMBLY
POLYCARBONATE SAFETY WINDOWS
NOTE: Installing a boom mower requires that all of the right side windows be
replaced with polycarbonate. Install the safety windows after all of the cab wiring and
mounting is done; and before the boom arm is mounted. Locate all the hardware in the
Parts Section on the Safety Screen page, when installing the polycarbonate.
Remove the right hand rail, the right rear window and the right door from the tractor
cab. Remove the hardware and check the parts section for which parts are re-used.
Wrap the trim seal around the polycarbonate and cut the trim to match the other end so a
seal will form to the frame. Apply the adhesive in the groove of the trim seal where the
polycarbonate sits and apply the trim seal to the polycarbonate. Add the hardware for
the existing holes to the polycarbonate and install the polycarbonate to the tractor frame.
Locate the 4 holes where the hand rail attaches to the cab. Place the front two
support brackets over the holes and attach the hand rail over the brackets with the
hardware provided. Place the bottom support bracket in the center of the bottom edge of
the door and mark the position of hte center hole. Drill one 3/8” hole through the door
frame. Use the hardware shown in the parts book to secure the bracket into place.
Locate the existing harware over the fender in the door frame of the cab. Position
the polycarbonate mount over the coresponding holes. Remove the existing hardware.
Attach the mount to the fender with the hardware provided. Drill a 5/16” hole through the
polycarbonate and secure the window to the mount.
BRACKETS
POLYCARBONATE
MOUNT
EXISTING
HARDWARE