Tiger Products Co., Ltd M105X/S - Manual (Page 41)

Assembly Section 2-13
ASSEMBLY
TRAVEL LOCK MOUNTING
Install the travel lock bracket with pin and clip on the draft beam. Slide the draft
beam and align the travel lock bracket hole with the mounting hole on the main frame.
Install the capscrew, lockwasher and hex nut as shown in the picture.
Raise the deck/flail to it’s upright position (Deck ear touches to stop bolt as
shown in the picture). Drill a 13/16” hole to the deck/flail ear through the draft beam
as shown below. Insert the supplied pin and clip through the hole.
STOP BOLT ADJUSTMENT
The stop bolt is not required on flail side mowers and should not be installed on
the combo draft beam.
NOTE: When the outboard cylinder is fully extended, the bonnet should be up
against the stop or if travel locks are installed, it should be up against the travel lock.
It may be necessary to use either external or internal slugs on the cylinder to get the
correct stroke. If the cutter head is against the stop and the cylinder has stoke
remaining, serious damage will occur.
Proceed to final preparation for operation instructions on the next page.