Toshiba 2400 - Manual (Page 53)

53 Getting Started
Connecting a mouse
5.375 x 8.375 ver 2.4.0
4 Complete the procedure by following steps 10 through 12
in
“Installing additional memory (optional)” on page 47 .
Checking total memory
When you add or remove memory, you can check that the
computer has recognized the change. To do this:
1 Click Start, Control Panel
2 Click Performance and Maintenance.
3 Click System.
4 The General tab view automatically appears and shows
the recognized memory.
5 If the computer does not recognize the memory
configuration, turn off the computer, remove the memory
slot cover, and make sure the memory module is seated
properly, as described in steps 8 and 9 of
“Installing
additional memory (optional)” on page 47 .
Connecting a mouse
You may want to use a mouse instead of the TouchPad, the
computer’s built-in pointing device.
To connect a mouse, plug the mouse cable into one of the
computer’s USB ports. You can connect it after you turn on
the computer.
The operating system automatically detects the mouse. The
mouse and TouchPad can be used at the same time.
Connecting a printer
You can connect a USB-compatible printer to your computer
through the USB ports. You can connect a USB printer after
you turn on the computer.
Alternatively, you can connect a parallel printer to the
computer’s parallel port.