Technicolor - Thomson VMD 6 - Manual (Page 66)

EN
65
2
1
USER MAINTENANCE
Cassette holder
cover
OPEN/EJECT
Switch
PUSH HERE
Cassette holder
Cover
Cleaning The Camcorder
1 To clean the exterior, wipe gently with a soft
cloth.
Put the cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again
with a dry cloth.
2 Press PUSH OPEN and open the LCD monitor.
Wipe gently with a soft cloth. Be careful not to
damage the monitor. Close the LCD monitor.
3 To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
4 To clean the viewfinder, raise it to the vertical
position. Carefully open the cover on the
bottom of the viewfinder
1 .
5 Insert a lens blower or soft cloth into the gap at
the bottom of the viewfinder and clean the
interior of the viewfinder with it
2 .
6 Close the cover. Tilt the viewfinder back to the
horizontal position.
NOTES:
● Avoid using strong cleaning agents such as benzine
or alcohol.
● Cleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
● Mould may form if the lens is left dirty.
● When using a cleaner or chemically treated cloth
refer to the cautions of each product.
After Use
1 Turn off the camcorder.
2 Slide and hold OPEN/EJECT in the direction of
the arrow, then pull the cassette holder cover
open until it locks. The cassette holder opens
automatically. Remove the cassette.
3 Press “PUSH HERE” to close the cassette holder.
•Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
4 Press BATTERY RELEASE and remove the battery
pack.
BATTERY
RELEASE Button
Remove.
Lens blower
VMD6 EN(40/80) 28/08/00, 16:08 65