Technicolor - Thomson VMD 6 - Manual (Page 8)

E N
7
1
3
2
To DC Input
connector To DC OUT
connector
To AC outlet
AC Power
Adapter/Charger
DC cord
ATTENTION:
Before detaching the power source,
make sure that the camcorder’s power
is turned off. Failure to do so can result
in a camcorder malfunction.
USING THE BATTERY PACK
1 Tilt the viewfinder upward 1 .
2 With the arrow on the battery pack pointing
downward, push the battery pack slightly against the
battery pack mount
2 , then slide down the battery
pack until it locks in place 3 .
•If the battery pack is attached with its mark set
in the wrong direction, a malfunction may occur.
To Detach The Battery Pack . . .
.... tilt the viewfinder upward 1 and slide the battery pack
up slightly while pressing BATTERY RELEASE to detach it.
Power cord
Approximate recording time
BATTERY RELEASE
Button
NOTES:
● Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
● Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
USING AC POWER
Use the AC Power Adapter/Charger (connect as shown in the illustration).
NOTES:
● The provided AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to
240 V.
● For other notes,
੬
pg. 6.
Battery pack
BAT 600
LCD monitor on/
Viewfinder off
1 hr.
(35 min.)
LCD monitor off/
Viewfinder on
1 hr. 15 min.
(40 min.)
( ) : when the video light is on.
VMD6 EN(02/39) 28/08/00, 15:46 7