Tiger Products Co., Ltd JD 5083E - Manual (Page 44)

Assembly Section 2-10
ASSEMBLY
HUSCO VALVE PLUMBING (SCV ONLY UNITS)
The tractor ports used are on the selective control valve (SCV). The SCV is
located between the right arm of the three point hitch and the axle. The pressure port
is located the closest to the axle. The excessive flow port is right next to the
pressure port. And the return port is located on the adjacent face. Refer to the
image below as a guide.
NOTE: To use the pressure port a 3/8 NPT pipe plug(B) must be inserted into the
port(C) - (refer to the illustration below and the Parts Section). Remove the plugs
covering the ports of the SCV ports. After the plug is removed, use a wrench to
tighten the plug(B) securely.
When the pressure port is active, install the adapters in their ports. The hose
from the pressure port goes to the “P” port of the husco valve. Next the return hose
from the lift valve goes back to the “T” port on the selective control valve. Plumb the
power beyond hose from the “PB” port on the husco valve to the “EF” port on the
SCV. See the parts pages for placement and the hardware used.
SELECTIVE CONTROL VALVE (SCV)