Tiger Products Co., Ltd JD 5083E - Manual (Page 82)

Cheetah Maintenance Section 4-4
MAINTENANCE
WEEKLY OR EVERY 50 HOURS
ITEM SERVICE COMMENTS
In Tank Hyd. Fluid Filter Change Change after the first 50 hours only,
(10 micron filter) then every 500 hours, yearly or if
indicated by the restriction indicator.
In-Line High Pressure Filter Change Change after the first 50 hours only,
(10 micron filter) then every 500 hours, yearly or if
indicated by the restriction indicator.
Chain Coupling Check
MONTHLY OR EVERY 150 HOURS
Hydraulic Fluid Level Check Add as needed
Hyd. Tank Breather Clean/Check/Replace Clean or replace element as required
YEARLY OR EVERY 500 HOURS
Spindle Grease Change
Hyd. Tank Fluid Change
In Tank Hyd. Fluid Filter Change
(10 micron filter)
In-Line High Pressure Filter Change or Change when indicated by restriction
(10 micron filter) indicator.
Hyd. Tank Breather Change
TROUBLE SHOOTING
SYMPTOMS CAUSE REMEDY
Vibration 1. Loose bolts 1. Check all bolts and tighten to
torque specs. in this section
2. Cutter assembly 2a. Check for damaged blades, disc.
Unbalanced or cutter shaft. Replace if needed.
2b. Check for wire, rope, etc.
entangled in cutter assembly
Mower will not lift 1. Hyd. Fluid low 1. Check and refill Hyd. Fluid
2. Leaks in line 2. Tighten or replace fittings and hoses
3. Faulty relief valve 3. Check pressure in line. Line
pressure in Control Valve
should be at least 2500 P.S.I.
4. Kinked or blocked 4. Clean or replace line.
5. Faulty cylinder
5. Inspect, repair or replace cylinder
Mower will not start 1. Blown fuse 1. Check fuse between mower switch
or run and ignition / replace
2. Ball valves closed 2. Make sure valves are open
3. Low oil level
3. Check Hyd. tank and fill
4. Line leak 4. Check all fittings and lines,