Topfield FREE TO AIR TF3100FEP PRO - Manual (Page 38)

P
O
S
ITI
O
N
E
R
S
E
TTI
N
G
G
U
ID
E
Positioner Setting Guide Positioner model only
Installation
Positioner Setting Guide
For the viewing of certain programs and satellites, the satellite and the antenna has to be
configured. This is possible through the Motorized Dish Setting menu.
NOTE: The positioner should be installed correctly, before proceeding this part of
manual.
Warning: Disconnect STB from mains supply, before installing the positioner
and/or skew motors.
Positioner
There are 4 wires from actuator motor. That is to say, M1, M2, Pulse(or reed) and
GND wires. Please check and follow the procedures.
A. Connect the GND wire to the GND terminal on your STB.
B. Connect the motor wires of actuator to the motor terminal(M1,M2) on your STB.
: Please do not connect the pulse(or reed) wires to the motor
terminals(M1,M2) on STB. It may break down your STB and Motor.
C. Connect the reed wires of actuator to the ‘Pulse’ terminal on your STB.
: Please do not connect the motor wires(M1,M2) to the
pulse terminal on STB. It may break down your STB and motor.
Skew
There are 3 wires from skew motor. That is to say, +5V, Skew and GND wires.
Please check and follow the procedures.
A. Connect the GND wire of skew motor to the GND terminal on your STB.
B. Connect the +5V wire of skew motor to the +5V terminal on your STB.
C. Connect the skew wire of skew motor to the Skew terminal on your STB.