Texas Instruments Serial Programming Adapter MSP430 - Manual (Page 24)

2-12
2.3.2 Return Values/Error Codes in .ini File
The error code is returned to the PC operating system and also is stored in
PRGS430.ini.
File in the [Options] section:
LastResult=0
0 Ok
2 Communication failed!
3 Target not connected!
4 Adapter not connected!
5 Wrong JTAG version!
6 PUC failed!
7 Synchronization with adapter failed!
8 The present adapter is not an MSP−PRGS430!
9 Unknown target!
10 Wrong target!
11 No target selected!
12 Target fuse is blown!
13 Blow fuse failed!
14 Missing setting of V
CC
!
15 Wrong V
CC
selected!
16 Wrong baudrate!
17 Communication port error!
18 DEVICE.CFG corrupted!
19 General error!
20 The selected range is invalid!
21 Wrong argument!
22 Error during file I/O
23 File type could not be detected!
24 Unexpected end of file!
25 PROJECT.INI corrupted!
26 Vcc voltage too low for selected function!
27 Fuse not release for this device!
101 Error at target address (during erase check or verify)
102 Unknown command line option
103 Command line option out of valid range
104 Filename mismatch
105 Error in device.cfg