Toto LVU2E1 - Manual (Page 23)

ENGLISH - 21 -
Miscellaneous
Gray shades are not displayed properly (discontinuity, non-smoothness).
Check the display color setting. Set it to 32 bit color for full 256 shades of gray.
Lightning-like noise occurs during switching to portrait orientation using NVRotate.
It occurs due to the high-speed drawing by NVRotate. It is not a failure.
Can I use any commercially available DVI cable?
No, use the DVI cable supplied with the TOTOKU display.
What is the display driver version?
The latest version as of July 2006 is 84.26.
Note:
• Drivers will be updated for improvement. Use the latest version.
• Setup methods may vary from version to version. Please follow the instructions.
• Make sure to uninstall the old version before installing the new version.
Driver upgrade history:
Version Release
Changes
84.26 Jul/06 (First version)
What are the restrictions for display settings when calibrating displays?
• When a primary display is set to 8 bit color, a secondary monochorme display cannot
be calibrated properly. In this case, set the primary display to 32 bit color or set the
monochrome display as primary.
• If gamma correction is working on the system, disable it.
• Calibration software for ME201L supports 32 bit color.
• Calibration software for ME213L/ME251i/ME315L/ME351i/ME511L/ME551i2 s/
ME551i2 support 32 bit color and fi xed gray palette.
• Calibration software for CCL202/CCL212/CCL250i/CCL316/CCL350i support 32 bit
color. Do not calibrate displays in 8/16 bit color mode.