Telstrat Argent - Manual (Page 13)

Argent Terminal Adaptor - User Guide
Version 1.1 Telstra Corporation Limited
Page 13/29 ACN 051 775 556
3.6.14 Point-to-Point Protocol (PPP) Installation
PPP is used to connect to Internet or other ISDN TAs using the common Windows, Unix,
Macintosh interfaces. Most commonly, it is used for Internet access.
PPP over a OnRamp ® 2 B-channel can be invoked via the V.24 Serial port, from a
Windows 95 PC or similar, by setting up Dial-up networking similar to the configuration
of a standard modem.
To use PPP, set up your computer as you would for connecting a standard modem - with
no parity, 8 data bits and one stop bit, (ie N, 8,1).
The Argent Terminal adaptor connects to a terminal or computer with a standard modem
cable. Plug the D25 male connector into the V.24 / RS232 Serial port on the ATA using a
standard straight through modem cable.
Connecting communications equipment, like a modem or router, to the ATA’s V.24 port
would require a crossover cable.
Follow the steps below to install the ATA as a Standard Modem
Check Braintree’s website (www.braintree.com.au) for the latest information on
installation.
1. Click on START
2. Click on Settings
3. Click on Control Panel
4. Double Click on Modem