Technicolor - Thomson DTH8657E - Manual (Page 5)

Automatic channel search
To view channels then record TV programmes with this recorder you must first install your region's
channels. Installation involves looking for then storing the channels for the different stations that can
be received by your aerial. Follow the instructions below to start then continue with the instructions
which are displayed on your TV screen.
1. Turn on your TV set.
2. Press the recorder’s STANDBY/ON key once.Wait a few seconds
until the language menu appears. If this menu is not displayed, after a
few seconds on your TV screen select the AV socket to which you
connected your recorder.
3. Select a language using the remote control's navigation keys ( ▼ , ▲ ,
OK) .
The language selection determines the language of the recorder’s menus, but
also the language for the dialogues and subtitles on DVD discs if the
language selected is also offered by the discs being played.
4. Select the country where you live then the installation method using
the remote control's navigation keys (
▼ , ▲ , OK) .
The channel installation starts. Wqit until the end of the channel search and
continue the installation by following the indications on the screen and using
the
▼
,
▲
, B , C and OK keys.
Note: Installation with a satellite or cable receiver is explained in the separate
“Quick Start Guide” document.
The navigation keys are used to select and confirm the menu functions.The
direction of the arrows indicates the way you move around in the.
3
EN EN
Connections and initial set up
AV 2 (SAT-CABLE-DECODER)
AV 1 (TV)
HDMI OUT
COAXIAL
DIGITAL AUDIO OUT
ANTENNA /CABLE
IN
OUT
OUTPUT COMPONENT VIDEO OUT
VIDEO
AUDIO
L
R
Y
Pb/Cb
Pr/Cr
AC 230 V
50 Hz
United kingdom
Ireland
Europe
Basic connections
The connections suggested below are recommended first of all for installing the channels explained
later on. By following, the instructions in this page you will avoid any setup problems related to the
interaction between several devices. If you have any other audio video devices, do not connect them
now; add them after you have installed the channels.
The mains
plug is used to
disconnect the
appliance from the grid.
It should be readily
accessible.
02_DTH8657_en.qxp 10/05/06 14:13 Page 3