Teac DA-88 - Manual

DA-88 quick ref.doc
10/14/97
7:27 PM
Page 1
© TEAC America, Inc., 1997 All rights reserved.
BASIC FUNCTIONS Software Version 4.01


Items marked SY are only available when the SY-88 is installed.
Function Display
LED
To Enter Function To Enter
Data
Remarks
1 Display ABS Time ABS Hold DISPLAY +
 - -
2 Display H:M:S:F TC difference DIFF SY DISPLAY - -
3 Display Sub-Frame difference “ SY DISPLAY - Press

to return to H:M:S:F display
4 Auto Offset Calculate & Store “ SY DISPLAY 
and
 Time code offset only
5 Display Generator Start Time & Enter
Data GEN SY DISPLAY 
or
 -
6 Column by column Generator or
Offset time Setting GEN
or
OFFSET
Hold

and

then
press DISPLAY

or

A period will start blinking in the Hours column, use

or

to enter hours. Press DISPLAY to move the
period to next column. After setting last column,
pressing DISPLAY will exit column setting mode
7 Display MEMO 1 & Enter data MEMO 1 DISPLAY 
or
 By pushing MEMO 1, point can be set on the fly
8 Display MEMO 2 & Enter data MEMO 2 DISPLAY 
or
 By pushing MEMO 2, point can be set on the fly
9 Display OFFSET & Enter data OFFSET DISPLAY 
or
 ABS time Offset entry in Frames only.
10 Display OFFSET & Enter Data “ SY DISPLAY 
or
 SMPTE T/C Offset entry in Frames, or when DISPLAY
is pressed again, in Sub-Frames.
11 Display PITCH & Enter data PITCH DISPLAY or VARI 
or
 -
12 Display Tape Time Code TC SY Hold DISPLAY +
 - -
13 Display User Bits on tape SY Hold

+ DISPLAY - TC LED will flash
14 Display Incoming Time Code “ SY Hold

+ Display - TC LED will flash. Press DISPLAY to exit.
15 Pull Up / Down mode setting “ SY Hold

and press Fs

or
 Press DISPLAY to exit
16 Display Pull Up / Down Status Any SY Press Fs button - Display will exit automatically