Tivoli Audio MUSIC SYSTEM - Manual (Page 7)

7
English
Figure 8 Figure 9
Figure 0
11. CLOCK: Press and hold to set the hour first. A beep will confirm you are in the clock set
mode. Use the volume knob to select the hour (Figure 6) and then press the volume knob
in to set and cycle to the minutes (Figure 7). The hour determines AM or PM. Adjusting the
hour does not affect the minutes and vise-versa. Repeat this process to set the year, month
and the day (Figure 8, 9 and 0). Once set, press the Clock button briefly to recall the date
and time whenever RDS or CD text is displayed. When the date is shown, only the month
and day will show (not the year).
Note: The non-US model uses a 24-hour clock format.
12. VOLUME/TREBLE: Rotate clockwise to increase the volume or counter-clockwise to
decrease the volume. The volume level is represented in numbers from 0 (no output) to 30
(maximum output). If the volume ever sounds distorted, reduce the level immediately. Push
in and rotate counter-clockwise to reduce the treble or clockwise to increase the treble.
Press the volume knob in to set or the setting will store automatically and the display will
return to its previous state. This knob is also used to adjust and enter selections (by pushing
the knob in) when setting the Clock and Alarms. Adjusting the volume during Snooze will
cancel the Snooze mode.
13. AUDIO: Push briefly to cycle through Stereo, SpacePhase
™ Wide mode, or Mono audio settings.
The SpacePhase ™ Wide mode setting is designed to create a more expansive soundstage,
while the Mono setting reduces multiplex noise on weak FM stations, making otherwise un-
listenable stations listenable. Regardless of the previous audio setting, the SpacePhase
™
Wide mode will automatically engage each time the Music System is turned on.
EQ: To temporarily turn the EQ off, press and hold the Audio button. The display will show
“EQ Off” and a confirmation beep will sound. The EQ will engage again automatically the next
time the Music System is turned on. To keep the EQ off, press and hold the Audio button and
the display will show “EQ Always Off” anda confirmation beep will sound. The EQ will remain
off until “EQ On” is selected. The EQ differs from Audio in that it enhances lower frequencies
primarily at lower volume levels. We suggest the rear Bass level be set to the center detent
position. Should the bass ever sound distorted, immediately lower the bass level and/or volume.
For more, see the section marked “Getting the most from your Music System.”
Figure  Figure