Transition Networks CSRFB10XX-100 - Manual (Page 4)

6
CSRFB10xx-100
24-hour Technical Support: 1-200-260-1312 -- International: 00-1-952-941-7600
Install the fiber cable
1. Locate or build IEEE 803.2 ™ compliant 100Base-FX fiber cable with male,
two-stranded TX to RX connectors installed at both ends.
2. Connect the fiber cables to the CSRFB10xx-100 media converter as described:
•
Connect the male TX cable connector to the female TX connector.
• Connect the male RX cable connector to the female RX connector.
3. Connect the fiber cables to the other converter (media converter, hub, etc.) as
described:
•
Connect the male TX cable connector to the female RX connector.
• Connect the male RX cable connector to the female TX connector.
Connect fiber cable
to media converter
as shown. Connect fiber cable
to other device
(media converter,
hub, etc.) as shown
RX
TX
RX
TX
Installation -- Continued
Install the twisted-pair copper cable
1. Locate IEEE 803.2 compliant 10Base-T or 100Base-TX cable with RJ-45
connectors installed on both ends.
2. Connect the RJ-45 connector at one end of the cable to the RJ-45 port
connector on the media converter.
3. Connect the RJ-45 connector at the other end of the cable to the RJ-45 port
connector on the other converter (switch, workstation, etc.).
Note: The MDI (straight-through) or MDI-X (crossover) cable connection is
configured automatically, when the AutoCross jumper is in the enabled
position.
RJ-45 Port
Media Converter
RJ-45 Port
On other device
(workstation, switch, etc.)
Point System Chassis
[email protected] -- Click the “Transition Now” link for a live Web chat. 7
Operation
Status LEDs
DPX LACT PWR
Li
nk
T
est
TX
RX
10
0B
as
e-F
X
10
/1
00
Ba
se
-T
X
CSRFB
LED 2
LED 1
AutoCross™
The AutoCross feature detects and configures the twisted-pair copper port on the
CSRFB10xx-100 media converter to the correct straight-through (MDI) or
crossover (MDI-X) configuration. This feature allows either MDI or MDI-X cable
to connect the media converter to converters such as hubs, transceivers, or network
interface cards (NICs). (This feature does not require operator intervention.)
LED Description
Power ON = Power
OFF = No power
Fiber LEDs
Link/Activity
Green ON Solid = Link, OFF = no link
Green Blink = Activity
Duplex (FD) Green ON = Full Duplex
OFF = Half Duplex
Copper LEDs
Link/Activity
(LED2)
Green ON Solid = Link, Blink = Activity
Blink = Rx Data
Duplex (LED2) Green ON = Full Duplex, Blink = Activity
Yellow ON = Half Duplex, Blink = Activity
Speed (LED1) Green=100 Mbps
Yellow =10 Mbps
Product Features
Link Test button
Press the Link Test button to bypass TLPT when enabled.
Note: This is a momentary override button; when
released, the connection will return to its previous
state.
Link Test
Button
Li
nk
T
es
t
10
/1
00
Ba
se
-T
X
CSRFB