Toshiba B-850 - Manual (Page 83)

APPENDIX 4 SYSTEM MODE EO1-33029
A4.4 Printer Parameter Fine Adjustment
A4- 7
A4.4 Printer Parameter
Fine Adjustment
(Cont.)
Cut Position Fine Adjustment
With this parameter you can fine adjust the cut position. When
“<3>ADJUST SET” appears, press the
[PAUSE] key twice.
[FEED] key: Pressing the [FEED] key one time causes a –0.5mm
change, up to –50.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a
+0.5mm change, up to +50.0 mm.
After completing the fine adjustment, press the [PAUSE] key.
&87$'-PP
[RESTART]
[FEED]
&87$'-PP
&87$'- PP
&87$'-PP
&87$'- PP
&87$'-PP
NOTES:
•
Cut issue is available only
when the optional cutter unit
(B-7208-QM) is installed.
When you need the cutter,
please contact your nearest
TOSHIBA TEC service
representative.
•
The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter.
The maximum cut position
fineadjustment value is
±50.0mm. When the value
reaches the maximum, the
value remains unchanged
even if the subsequent fine
adjustment is performed.
Cut Position Fine Adjustment
(Example)