Tyan Computer TIGER S5350 - Manual (Page 28)

Tiger i7320 S5350 Chapter 2: Board Installation
2-21
http://www.tyan.com
2.11 Installing the Power Supply
There are two power connectors on your Tiger i7320 S5350. The Tiger i7320 S5350 requires
that you have an EPS12V power supply that has a 24-pin and an 8-pin power connector.
Please be aware that using of the incompatible power supplies with the board can
damage the motherboard and/or CPU(s).
Disconnect power supply from electrical outlet
1. Connect the EP12V 8-pin power connector
2. Connect the EP12V 24-pin power connector
3. Connect power cable to power supply to power outlet
Make sure you have connected both connectors before attempting to apply power to the
board.
Note
Unplug the power supply before plugging in the 24-pin and 8-pin power
cables to motherboard.
2.12 Finishing Up
Before closing up your chassis, make sure that all cables and wires are connected properly,
especially IDE cables and most importantly, jumpers. You may have difficulty powering on
your system if the motherboard jumpers are not set correctly.
If you experience difficulty, you can find help by asking your vendor for assistance. If they are
not available for assistance, please find setup information and documentation online at our
website (www.tyan.com) or by calling your vendor’s support line.