Tanaka POLE EDGERS TPE-25OPF - Manual (Page 5)

www.tanaka-usa.com
4 [email protected]
Owner’s Manual TPE-2501,TPE-2510,TPE-270PF/PN,TPE-250PF
3. Assembly procedures.
Drive shaft to engine (Fig. 1 -1)
Loosen tube locking bolt (1) about ten turns so that the bolt point
will not obstruct drive shaft tube to be inserted. When inserting
drive shaft tube, hold the tube locking bolt outward preventing
inside fitting from obstructing as well.
Insert the drive shaft into the clutch case of the engine properly
until the marked position (2) on the drive shaft tube meets the
clutch case.
NOTE!
When it is hard to insert drive shaft up to the marked position on
the drive shaft tube, turn drive shaft by the cutter mounting end
clockwise or counterclockwise. Tighten tube locking bolt lining up
the hole in the shaft tube.
Then tighten clamp bolt securely (3).
Installation of handle (Fig. 1-2)
Attach the handle to the drive shaft tube with the angle towards the
engine.
Adjust the location to the most comfortable position before
operation.
Throttle wire/stop cord
Remove air cleaner cover. (Fig. 1-3)
Connect stop cords. (Fig. 1 -4)
Connect throttle wire end to carburetor. (Fig. 1 -5)
Cover throttle wire and stop cords together with protective tube provided up to air cleaner cover. (Fig. 1-6)