Tyco Electronics ET 1900L - Manual (Page 9)

Elo TouchSystems 1900L User Guide 9
To connect the touchmonitor to the computer:
1 Tilt the monitor to reveal the connector panel in the recessed area underneath the
bottom edge of the monitor.
2 Connect the AC power cable to the connector panel and connect the other end to the
power outlet.
3 Connect either the USB cable OR the serial cable to the connector panel. Note: Do
not use both. This cable connects the touchmonitor to your computer. Attach the
other end to your computer.
4 Connect the video cable (VGA) or the DVI-D cable to the connector panel. Tighten
by turning the two thumb screws clockwise to ensure proper grounding. Connect the
other end to your computer.
5 Connect the audio cable to the Audio Input on the connector panel and connect the
other end to your computer.
6 Press the power button on the side panel of the monitor to turn on the monitor.
Connecting the Cables to the Touchmonitor and Computer
Connector Panel Underneath the Monitor
Power VGA DVI-D USB LED DC
in
Audio
Input
Audio
Output
Serial