Thermador PROFESSIONAL PH PH54 - Manual (Page 6)

English 4
Appliance Installation
CAUTION:
Vent unit to the outside of building only.
The hood can be mounted on a wall or suspended from a
cabinet. Both vertical and horizontal discharge are possible
with either mounting method.
Discharge Direction:
The hood is shipped ready for vertical discharge. To
change to horizontal discharge, move the discharge cover
shown in Figure 1 to the top of the hood. The plate is held
in place by four (4) screws.
Assembly of the Transition:
The supplied transition mounts to the top or rear of the
hood depending on the discharge direction.
1. Align mounting holes at base of transition with
mounting holes on 1/2” flange located at the top or rear
of the hood, depending on direction of discharge.
2. Fasten transition to hood using two (2) # 8 sheet metal
screws (included with hood).
3. Seal connection between transition and hood with duct
tape.
4. Remove tape holding damper closed.
See Figure 2 for overall hood dimensions.
* Varies by model.
Note:
Read Remote Control Installation Instructions before
continuing if using this accessory.
Figure 1: Discharge Direction
This opening
is covered for
horizontal
discharge
This opening
is covered
for vertical
discharge
Figure 2: Overall Dimensions
30", 36", 42", 48", 54"*
18"
24", 27"*