Sending tone signal (for pulse service user), Muting, Paging – Toshiba FT-8001 AW User Manual
Page 14: Out of range
13
8. SENDING TONE SIGNAL (for Pulse service user)
Even if you have Pulse service (the dial mode is set to Pulse), you can
use this phone with banking and other phone services requiring touch
tone signals.
q Dial the service number and wait for the connection.
w Press
TONE/
, then enter the numbers required. You will hear the
tones on the line.
9. MUTING
Press
MUTE
to turn off the microphone during a conversation.
The TALK/BATT LOW LED blinks. You may speak to someone in the
room without the caller overhearing.
To resume normal conversation, press
MUTE
or
TALK
.
10. PAGING
To locate the handset while it is off the base, press
PAGE
on the base
unit. The handset beeps for 60 seconds, and IN USE/CHARGE LED
blinks. To stop paging, press
PAGE
or any key at the handset, or return
the handset to the base unit.
Note
You cannot page the handset during a call.
11. OUT OF RANGE
During a call, as you begin to move too far from the base, you first hear
a clicking sound. As you travel farther, the noise increases. Then you
should move close to the base unit. If you travel out-of-range, your call
terminates.