TechniSat DigiBox VIACCESS - Manual (Page 18)

Yellow bar: good reception
Green bar: excellent reception
6 Operation
6.1 Switching on and off
> Use the key
On/standby
on the receiver or on the remote control to switch the
receiver on.
> Pressing the same key on the receiver or on the remote control again will switch the
receiver off again.
> The receiver is now in standby mode, the display on the receiver will now show the
time.
If the time is not shown, this must still be acquired by the receiver. In Germany, it is
sufficient to switch the receiver on, and to select Channel 1 (ARD) of the public servi-
ce broadcast system for the time to be acquired automatically.
6.2 Programme Selection
6.2.1 Using the Programme up/down keys
>
Use the
Channel up/down
keys either on the receiver front panel or on the remote
control to move up or down the list one channel at a time.
6.2.2 Using the Numeric Key Pad
>
Use the numeric key pad to enter the desired programme/channel number directly:
For example:
1 Programme/channel 1
1 , followed by 4 Programme/channel 14
2
,followed by
3
, followed by
4
Programme/channel
234
When entering programme numbers consisting of more than one digit, you have about 3
seconds after pressing one digit to enter the next digit, in order to complete the entry in such
a way that the receiver recognises all digits as part of one selection.
If you are entering a programme number with only one or two digits, you can speed up the
selection process by pressing
OK
after entering the last digit.
6.2.3 Using the Programme List
>
Press the key
OK
A list of programmes will now be displayed.
IIf the receiver is in TV mode, only TV programmes will be shown, and in Radio mode only
radio programmes will be displayed. The programme currently selected is highlighted in red.
>
You can now proceed to mark the desired programme in blue by using the up/down
arrow keys.
18
bed_anl_DigiBox_Viaccess_englisch.qxd 13.08.01 11:42 Seite 18