Figure 3.3.1, Done. you can start to use the system now, Figure 3.3.2 – Thecus Technology i Series User Manual
Page 18
Step 1:
Select “Quick install” then choose the RAID level to set. Please refer to
Figure 3.3.1. After choosing the RAID level, click “
”, which
links to another page, user can set up “LUN” here.
Figure 3.3.1
Step 2:
Please select a LUN number. Access control of host would show as a
wildcard “*”, which means every host can access this volume. In this page, the
“Volume size” can be changed. The maximum volume size is shown. To re-enter
the size be sure it has to be less or equal to maximum volume size. Then click
“
”.
Step 3:
Confirm page. Click “
” if all setups are correct. Then
a page with the “User data volume” just been created will be shown as Figure
3.3.2.
Done.
You can start to use the system now.
Figure 3.3.2
(Figure 3.3.2: A RAID 0 user data volume with the UDV name “QUICK98273”, named by the
system itself, with the total available volume size 222GB.)
- 18 -