Toshiba TEC FS-1450 - Manual (Page 61)

– 55 –
EO1-11097
RECALL ENTRY
This operation recalls a order table.
| Order No. | [RECALL] Sale finalization
Additional order entry [TOTAL]
Sale finalization
NOTE: Recall Entry can be canceled.
To end the entry, follow the procedure described below.
[RECALL] [ITEM CORR] [AT/TL] (or other media)
[ALL VOID] [ITEM CORR]
VALIDATION PRINT
NOTES: 1. If the "SLIP" lamp flickers during registra-
tions, it indicates that the last item just
entered is programmed to require valida-
tion print. In this case, no other opera-
tions can follow until the validation print of
the item is first executed.
2. Because printing occurs on the front side
of the slip, please be certain to insert the
slip into the validation with the printing
side frontward.
3. No other operations can follow until the
validation slip once printed is withdrawn.
4. The following are programmable selec-
tions relating to validation:
(1) PRINT FORMAT
a) Date Print/Non-print
b) Consecutive No. Print/Non-print
c) Cashier No. Print/Non-print
(2) MULTI- or SINGLE-VALIDATION (Number of times of validation print allowed for the
same item)
(3) VALIDATION COMPULSORY status on Media Keys and other transaction keys.
5. When the sale-finalizing media key is programmed with Validation Compulsory status and
the key is used with over-tendering, the drawer will open on the compulsory validation print.
6. When the sale-finalizing media key is programmed with Validation Compulsory status and
the key is used with equal-tendering or used as Total key, the drawer will open even if the
status "Not Open" is programmed on the key.
OPERATION
OPERATION
After entering the required
item through a transaction
key or media key. (
NOTE 1)
Insert a validation slip into
the validation slot. make
sure that the "SLIP" lamp is
steadily lit. (
NOTE 2)
[VALIDATE]
Validation Slot
Validation Slip