Reverb, 6 – basic recording – Tascam DP-008 User Manual
Page 46
46
TASCAM DP-008
Set the track EQ using the
EQ SETTING
screen.
1 Press the
EQ
key to open the
EQ SETTING
screen.
2 Set the track EQ (equalizer).
The track equalizer has the following
parameters.
Parameter
Setting value
EQ-SWITCH
(track EQ
switch)
ON/OFF
(Default: OFF)
Hi-F
(high frequency
range)
1.7 kHz – 18 kHz
(Default: 5 kHz)
Hi-G
(high range
gain)
±12 dB
(Default: 0.0 dB)
Lo-F
(low frequency
range)
32 Hz – 1.6 kHz
(Default: 350 Hz)
Lo-G
(low range
gain)
±12 dB
(Default: 0.0 dB)
Use the
F1
(˙) and
F2
(¥) keys to switch
tracks.
Use the
F3
(§) and
F4
(¶) keys to select
parameters.
Use the
DATA
wheel to adjust the
parameters.
3 After making the track EQ settings,
press the
HOME
key to return to the
Home Screen.
NOTE
When track EQ is ON for a track, the track is
shown on the Home Screen as in the illus-
tration below.
Track EQ is ON
Reverb
This unit has six types of reverb effects.
Adjust the level of the signal sent to the reverb
effect from each track by using their
REVERB
knobs.
The signals are sent to the reverb effect after
track EQ (equalizer) is applied.
1 Press the
REVERB
key to open the
REVERB
SETTING
screen.
2 Adjust the reverb settings for the
following parameters.
Parameter
Setting value
TYPE
Hall 1/Hall 2/Room/
Studio/Plate 1/Plate 2
(Default: Hall 1)
6 – Basic Recording