Tyco Electronics M/A-COM M7200 - Manual (Page 25)

MM23016
6.18.1 Enabling Stealth Mode
1. Using , scroll through the menu until “StealthMenu” appears.
2. To immediately turn stealth mode on, press up or down with .
3. To turn stealth mode off, press any button on the radio’s front panel.
6.18.2 Disabling Stealth Mode
Pressing any radio button other than the mic’s PTT button or the emergency button on front panel will
rn stealth mode off. For example, pressing the MENU button on the front panel will turn
ff.
immediately tu
stealth mode o
With stealth mode on, pressing any radio button (other than the mic’s PTT button
or the emergency button) on front panel will immediately turn stealth mode off. For
example, pressing the
button on the fro  nt panel will turn stealth mode off.
6.19 DIO LEVEL
he menus. Side tone audio level can be adjusted or turned
the “Side Menu” and select “Off” from the menu choices.
re not heard when the menu buttons are pressed, the side
ff.”
1.
ADJUSTING SIDE TONE AU
The radio sounds confirming tones called “side tones” when its buttons are pressed. Most users find this
audible confirmation helpful when navigating t
completely off using the “Side Menu.”
For covert operations, it may be necessary to turn off side tones. For safety’s sake, turning off the radio
during covert operations is not recommended.
To temporarily disable the side tones that could expose the user’s presence and position, use the menu
buttons to access
If the radio is operating properly but side tones a
tones are probably turned off. To turn them back on, access the “Side Tone” menu and select a setting
other than “o
Use the following procedure set side tone level:
Use to cycle through the menu until the “Side Menu” appears in the bottom line of the
display.
to change to the desired le 2. Use vel (Off, Low, Medium, and High). To turn side tones
letely
6.20 CHANGE OPERATING
1.
comp off, use the “Off” setting.
MODE
Use to cycle through the menu until the “Mode Menu” appears in the bottom line of the
display.
to choose an available mode. Press MENU and confirm (Y/N) with and MENU 2. Use
again.
3. Press the MENU button to confirm.
25