1 checking or changing active scan mode, 2 scanning priority, 1 changing scanning priority – Tyco Electronics M/A-COM M7200 User Manual
Page 29: Checking or changing active scan mode, Scanning priority, Table 6-5: scan modes
MM23016
Table 6-5: Scan Modes
SCAN
MODE
EXPLANATION
No Scan
Eliminates distractions.
Full communications (transmit and receive) on selected talk group.
No calls received from other talk groups.
Normal
(Default)
Full communications (transmit and receive) on the selected talk group.
Scans all talk groups in the active profile that are not locked out.
Receive calls from more than one talk group, if available from the current site.
Allows dragging of the selected, default emergency, P1, and P2 talk groups to the site on
which the radio is registered. (If other calls are available at the site, they also can be heard
but they will not be actively dragged.)
An emergency-enabled talk group is only dragged if it is in emergency mode.
Fixed
The priority groups are fixed to the selected profile’s pre-defined P1 and P2 groups
(configured via the UAS). In this mode, P1 and P2 groups CANNOT be locked out.
6.25.1 Checking or Changing Active Scan Mode
The currently active scan mode does not appear in the dwell display. To check it, access “ScnModeMenu”
and observe it in the top line of the display. To change the active scan mode:
1. Use
to scroll through the menus until “ScnModeMenu” appears in the display.
2. Use
to scroll through the scan options until the desired mode appears. See Table 6-5.
6.25.2 Scanning Priority
The following lists the scanning priority order (from highest to lowest):
1. Selected talk group in emergency state.
2. Default emergency group in emergency state.
3. Selected talk group.
4. Emergency capable group in emergency state
5. Priority 1 talk group.
6. Priority 2 talk group.
7. Other (non-priority)
6.25.2.1 Changing Scanning Priority
Follow this procedure to set talk groups in the current profile as the Priority 1 or Priority 2 talk group:
1. Use
to scroll through the menu until “Priority1” or “Priority2” appears in the bottom line of
the display (Priority1 group has higher priority than the Priorty2 group. The talk group currently set
as the priority talk group appears in the top line of the display.
2. Use
to select a new priority talk group.
29