10additional handsets and bases – Topcom OGATECH OG-R400 User Manual
Page 21
OGATECH OG-R400
OGATECH OG-R400
21
ENGLISH
9.8.2 To set and select the sending SMS Centre number
•
From the standby screen, press SMS to open the SMS menu.
•
Scroll to Settings and press OK.
•
Press OK to open Service Centres menu.
•
Scroll to Sending Centre and select OK.
•
The current stored number will be shown. Press Clear and enter the new number.
•
Press OK to store the number.
10ADDITIONAL HANDSETS AND BASES
You can subscribe up to 5 handsets on a OGATECH OG-R400 base. Each handset can
register to 4 base stations and the user can select which base he wants to use.
10.1 ADDING A NEW HANDSET
First put the base into registration mode:
•
Press and hold the paging button on the base until you hear two beeps.
•
The
LED will start to blink on the base for 90 seconds. During that time the base is
ready to register a handset.
On the handset:
•
Select Menu to open the menu.
•
Select Registration with the navigator and press OK.
•
Select Register Handset with the navigator and press OK.
•
Select the number of the base to be associated with the handset (1 to 4). Confirm by
pressing OK.
•
Enter the system PIN (0000 by default) and confirm with OK. A series of numbers
appears on the screen, representing the base ID. Confirm with 0K. Your handset is
registered.
10.2 REMOVING A HANDSET
This procedure needs to be carried out on a different handset from the one you want to
uninstall.
•
Select Menu by pressing the left menu key.
•
Select Registration with the navigator and press OK.
•
Select De-register with the navigator and press OK. Enter the system PIN (0000 by
default) and press OK.
•
Select the handset to uninstall with the navigator and press OK.
10.3 SELECT A BASE
You can switch your OGATECH OG-R400 handset between bases. You can also set it to
automatically base select with the strongest signal. The handset must first be registered with
each base individually.
•
Press MENU then scroll to Registration and press OK.
•
Scroll to Select Base then press OK. The current base being used is highlighted.
!! Only needed when you have deregistered a handset or when you bought a
new one !!