TOA Electronics HX-5B - Manual (Page 11)

11
Step 3. Fix the suspension bracket and the front bar with the bolts removed in step 2.
Step 4. For vertical suspension: Turn the speaker system upside down. Then, mount the suspension bracket
in the same manner as described in steps 2 and 3.
Observe the following instructions to tighten the bolts securely.
Failure to do this could cause the speaker to fall, potentially
resulting in damage and/or personal injury.
• Ensure that each bolt is correctly inserted into its slot before
tightening it.
• Bolts can be tightened using either a Phillips screwdriver or a
wrench, but be sure to finish the tightening with the wrench to
ensure optimum tightness.
WARNING
The figure on the right is for the
horizontal suspension of speaker system.
For the vertical suspension, the work is
done on either module to be suspended.
Suspension bracket
(supplied)
Front bar
Suspension bracket (supplied)
Speaker grill
Speaker
Sponge
Punched grill
Ensure that the sponge is fitted in the slot.
Step 5. Replace the removed speaker grill.
Be sure to use the supplied hex head wrench to tighten the fixing screws.