Telex IP-223 - Manual (Page 101)

103
Crosspatch Setup Window
Enable Line – Line Check Box
The Enable Line – Line check box indicates whether or not audio can be routed from one line to another line. If selected,
audio is routed from one line to the other line. TX traffic from the console overrides the crosspatch to allow the console
operator to take control of the line.
Start Patch FTone Drop Down Menu
NOTE: When using the Start and Stop FTone, the Line-Line check box must NOT be selected.
The Start Patch FTone drop down menu identifies the Ethernet function tone selection that starts a crosspatch between line 1
and line 2.
Stop Patch FTone Drop Down Menu
The Stop Patch FTone drop down menu identifies Ethernet function tone selection that stops a crosspatch between line 1 and
line 2.
RCP Enable Check Box
The RCP Enable check box indicates whether or not RCP (Remote Crosspatch) is enabled. If selected, RCP is enabled.
Dialing Digits Field
The Dialing Digits field identifies the number of DTMF (Dual Tone Multi-Frequency) digits allowed in the Drop All, Add
String, and Delete String fields on the window.
The entry can be 2, 3, or 4.
Interdigit Time Field
The Interdigit Time field identifies the amount of time, in ms, allowed between DTMF digits before a reset occurs. If a reset
occurs, the DTMF sequence must be started again.
This range for this field is 0 to 32000ms
Beep Dly Field
The Beep Dly field identifies the amount of time, in ms, between the digit string detection and status beeps echoed back to the
hand-held radio.
The range for this field is 0 to 5000ms.
Local Setup
Remote Setup