Telex IP-223 - Manual (Page 55)

57
Per Line Setup Window—Local, Tone, and Console Mode Configuration
Line 2 Button
The Line 2 button is used to navigate to the Per Line Setup window for Line 2 configuration.
Submit Button
To permanently save changes, do the following.
1. Click Submit.
The console name appears at the top of the Welcome window.
2. Click Save to EEPROM.
The Save to EEPROM window opens.
3. Click Save Parameters.
Changes are now permanently saved to the IP-223 console.
Line Mode Status Field
The Line Mode Status field displays the line type assigned to the line in the “Multicast Address Setup Window” on page 49.
With the exception of digital output, CTCSS frequency, CTCSS default system and chan fields in the Function Tone Setup
section, the Per Line Setup window for Local, Tone, or Console mode contains the same configuration options and are
discussed below.
Port Enabled Check Box
The Port Enabled check box indicates whether or not the port is enabled. If selected, the port is enabled and selection of
transmission or play received audio is allowed.
LAM Enabled Check Box
The LAM (Line Activity Monitor) Enabled check box is used to monitor the line for the signal level configured in the LAM
Level field. see “LAM Level Field” on page 61.
COR Enabled Check Box
The COR Enabled check box indicates whether or not the COR I/O pins (DiG6, pin 20 of the DB25 connector) are enabled. If
selected, the IP-223 monitors the COR for line activity.
COR Active High check box
The COR Active High check box indicates whether or not the polarity of the COR is high. If selected, the COR active signal
is high.
NOTE: LAM and COR can both be selected at the same time.
NOTE: LAM and COR are used to check audio signal for processing.
Always On Radio Button
The Always On radio button indicates whether or not CTCSS is ON at all times.
COR Setup
CTCSS Setup