Technics SC-EH760 - Manual (Page 20)

Changing sound field and quality
RQT5355
20
SC-EH760
SC-EH760
SC-EH760
SC-EH560
SC-EH560
SC-EH560
EQ
B
EQ
1 1
3
2
1
2
2
MULTI
CONTROL
1 2
2
3
3D AI EQ/
M.EQ BAND
FLAT
HEAVY
CLEAR
HALL
AI-EQ
M.EQ
A
FLAT
HEAVY
CLEAR
AI-EQ
M.EQ
HALL
1 3
MULTI JOG
EQ
MULTI JOG
MULTI JOG
MULTI JOG
FLAT
HEAVY
CLEAR
HALL
AI-EQ
M.EQ
LOW
MID
HIGH
FLAT
HEAVY
CLEAR
HALL
AI-EQ
M.EQ
1
2
FLAT
HEAVY
CLEAR
HALL
AI-EQ
M.EQ
a
C
FLAT
HEAVY
CLEAR
HALL
AI-EQ
M.EQ
FLAT
HEAVY
CLEAR
HALL
AI-EQ
M.EQ b c d
»
A
Changing sound field and
quality
Changes to sound field and quality have no effect on recordings.
[SC-EH760]
Turn [MULTI JOG] to select a setting.
[SC-EH560]
Press [EQ] to select a setting.
Each time you turn [MULTI JOG] (SC-EH760) or press [EQ]
(SC-EH560):
HEAVY:
Adds punch to rock.
CLEAR: Clarifies higher sounds.
HALL: Expands sound to make you feel like you were in a hall.
AI-EQ: Adjust sound with the acoustic image equalizer
(
➡ page 21).
M.EQ: Create your own effects ( ➡ see below).
FLAT: Canceled (no effect is added).
On the remote control
Press [EQ].
Note
Turn off the effect if sound quality reduces when using HALL or 3D AI
EQ with a source.
»
B Using the manual equalizer
Create your own sound quality effects.
1
[SC-EH760]
Turn [MULTI JOG] to select “M.EQ”.
[SC-EH560]
Press [EQ] to select “M.EQ”.
2
Press [3D AI EQ/M.EQ BAND] to se-
lect the band.
Each time you press the button:
LOW
> MID > HIGH
^------------------------}
3
Use [
"
,
!
,
#
,
$
] to make the re-
quired curve.
1 Select the frequency you want to use as the peak with [ " ,
! ].
2 Adjust the level of the peak with [ # , $ ].
³ Adjacent frequencies are adjusted at the same time to
maintain a smooth curve.
³ When you have adjusted the curve, you can move the
peak of the curve by pressing [
" , ! ] ( a ).
Repeat steps 2 and 3 to adjust the three bands.
The original display is restored on the display panel in about
5 seconds.
To cancel
Turn [MULTI JOG] (SC-EH760) or press [EQ] (SC-EH560) to select
“FLAT”.
Note
³ The changes you make are stored and automatically recalled the
next time you select “M.EQ”.
³ After making a curve in one band, any adjustments in another band
make a curve that is a combination of the two.
[C] To flatten the curves in all three bands
Set the frequencies b in LOW, c in MID, and d in HIGH to flat.
(On the tuner amplifier)
(On the sound processor)
(On the tuner amplifier)
(On the sound processor)
(On the sound processor)