Teac AD-800 - Manual (Page 33)

33
EN
GL
IS
H
Recording from an external source
Prepare to start playback of the source device.
Example: Set the source selection of an amplifier.
Set the playback media in a connected player.
To record from a tuner, tune in a station.
8
Press the RECORD TAPE button again to start recording.
When recording from an external source, you must also start
playback of the source.
The red indicator above the RECORD TAPE button and the
icon on the display stop blinking.
CAUTION
Do not turn the unit off or disconnect the power cord
during recording. Doing so could damage the unit and
connected devices.
To stop recording temporarily, press the TAPE Pause (+) button.
Press the button again to resume recording.
Recording from a CD or a USB storage device
When source playback stops, recording also automatically stops.
To stop recording, press the TAPE Stop (
)) button. Doing this
also stops playback of the recording source.

During two-side recording to a tape, if “side A” of the tape ends
in the middle of a track/file while recording from a CD or USB
device, the unit starts recording again on “side B” from the
beginning of the track/file that had been interrupted.
Recording from an external source
When source playback stops, recording does not automatically
stop. Press the TAPE Stop (
)) button to stop recording.
6
Adjust the recording level.
Before recording, adjust the recording level. Failure to do so
could cause the recorded sound to be distorted or noisy.
1. Play the source (external source) to be recorded.
2. Use the REC LEVEL knob to adjust the recording level so
that the loudest sound does not continually exceed the “0”
indicator on the peak level meter.

Different sources to be recorded have different volumes. In
order to record at the optimal volume for each source, it is
necessary to adjust the recording level for each source.
7
Prepare a recording source.
Recording from a CD
To record all the tracks/files on a CD, stop the disc first. To record
only some of the tracks/files on a CD, pause at the beginning of
the part that you want to record.
You can also record tracks in programmed order. For information
about how to set the program, see page 21.
Recording from a USB storage device
To record the entire contents of the USB device, stop the unit.
To record from the middle of the USB device, pause at the point
from where you want to start recording.
You can also record tracks in programmed order. For information
about how to set the program, see page 21.

See page 38 for information about the playback order of MP3
files.