Texas Instruments TMS320VC5402 - Manual (Page 26)

TMS320VC5402
FIXEDĆPOINT DIGITAL SIGNAL PROCESSOR
SPRS079E – OCTOBER 1998 – REVISED AUGUST 2000
26 POST OFFICE BOX 1443
•
HOUSTON, TEXAS 77251–1443
DMA channel interrupt selection
The DMA controller can generate a CPU interrupt for each of the six channels. However, the interrupt sources
for channels 0,1, 2, and 3 are multiplexed with other interrupt sources. DMA channels 2 and 3 share an interrupt
line with the receive and transmit portions of McBSP1 (IMR/IFR bits 10 and 11), and DMA channel 1 shares an
interrupt line with timer 1 (IMR/IFR bit 7). The interrupt source for DMA channel 0 is shared with a reserved
interrupt source. When the ’5402 is reset, the interrupts from these four DMA channels are deselected. The
INTSEL bit field in the DMA channel priority and enable control (DMPREC) register can be used to select these
interrupts, as shown in Table 8.
Table 8. DMA Channel Interrupt Selection
INTSEL Value IMR/IFR[6] IMR/IFR[7] IMR/IFR[10] IMR/IFR[11]
00b (reset) Reserved TINT1 BRINT1 BXINT1
01b Reserved TINT1 DMAC2 DMAC3
10b DMAC0 DMAC1 DMAC2 DMAC3
11b Reserved