Topcom ALLURE 270 - Manual (Page 16)

16 Topcom Allure 270
Topcom Allure 270
13.6 Playback of Incoming Messages
• Press to play all new messages. For each message, the internal voice announces the
day and time the message was recorded.
• During playback, you can go to next message by pressing or to the previous message
by pressing .
• To stop playback press .
• To delete the actual message press and hold button during playback of the message.
• To increase the volume during playback, press briefly.
• To decrease the volume, press briefly.
• After you have listened to the new messages, press the and hold to listen to all stored
messages.
13.7 Recording a conversation
A conversation of maximum 3 minutes can be recorded.
To start recording, press for 3 seconds. A beep will confirm that the recording started.
To end recording, press again.
To playback, press briefly in standby.
13.8 Memory Full
The display indicates when the memory is full.
When there is a new incomming call when the memory is full, the oldest message will be
deleted.
13.9 Remote Operation
The answering machine can be operated remotely using a touch-tone phone (DTMF tone
selection system).
13.9.1 Setting the security code
The 4 digit remote code is necessary for remote operation (default: 0123).
To set the code:
•
Press for 3 seconds, the display language is shown.
• Press repeatedly until ‘SET REMOTE CODE‘ is displayed.
• Enter the new code by means of the numerical keypad.
• Press confirm.
If no button is pressed within 10 seconds, the unit will return to standby mode.