Topcom ALLURE 270 - Manual (Page 17)

Topcom Allure 270 17
Topcom Allure 270
ENGLIS
H
13.9.2 Using the remote operation
•
Call your machine, the unit will turn on after 10 rings and you will hear the OGM
message.
• After the beep, slowly dial the Security code, you will hear one short beeps for
confirmation.
• Enter the next codes to use the desired function.
14 Technical Data
Dialing mode: Tone (DTMF)
Flash: 100/300/600ms
Caller ID: DTMF/FSK
Total recording time: 17 minutes (including OGM, ICM and Conversation
recording time)
Batteries: 3 x 1.5V, AAA non-rechargeable
Power supply: DC 9V
Ambient temperature: +5 °C to +45 °C
Permitted relative air humidity: 25 to 85 %
#1
#2
#3
#4
#5
#7
#8
#9
#0
*1
*2
*3
*4
*5
Broadcast the next message
Broadcast the previous message
Delete the actual message
To stop the operation
To broadcast the outgoing message (Press */# to stop)
To broadcast the message (Press */# to stop)
To broadcast all messages
To broadcast the new messages
Exit the remote control
To change OGM1
To change OGM2
To set the special incoming number. Enter the number and press # to confirm. The
number will be broadcasted for confirmation
To set the monitor function OFF, when the monitor function is on, you can hear the
noise in the room nearby the telephone
To set the monitor function ON