Technicolor - Thomson DCD-SA1 - Manual (Page 7)

ENGLISH
7
NOTE:
• Do not short-circuit the hot or cold pin with the GND pin.
• Connect as shown in the figure using a Cannon connector (XLR-3-32 type) cord. (commercially available)
• Cannon connector signal layout
1 2
3
Line up the protruding part of
the connector with this slot.
1: GND
2: COLD
3: HOT
w BALANCED
DCD-SA1 Amplifier
8 9
B
(2) Connections to the digital output jack (COAXIAL/OPTICAL)
DCD-SA1
Digital audio
input connector
(OPTICAL) Digital audio
input connector
(COAXIAL)
CD Recorder, MD Recorder, etc.
Optical fiber cable (commercially available)
75Ω/ohms pin-plug cable (commercially available)
(or)
(3) Connections to the digital input jack (COAXIAL/OPTICAL)
NOTE:
• Only linear PCM signals with a sampling frequency of 32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz or 192 kHz can be played
on this set. Do not input any signals other than linear PCM signals (CD-ROM, Dolby Digital, DTS signals, etc.). Doing so will generate
noise that could damage the speakers.
8 9
B
DCD-SA1
Digital audio
output connector
(OPTICAL) Digital audio
output connector
(COAXIAL)
CD Transport, MD Recorder, etc.
Optical fiber cable (commercially available)
75Ω/ohms pin-plug cable (commercially available)
(or)
NOTE:
• With Super Audio CDs, no digital signals are output.