Toshiba 32AV500A - Manual (Page 30)

30
Connecting your TV
HDMI (type A connector)-to-DVI adapter cable
For proper operation, the length of an HDMI-to-DVI adapter
cable should not exceed 3m. The recommended length is 2m.
Standard analog audio cables
An HDMI-to-DVI adapter cable transfers only video.
Separate analog audio cables are required.
Note:
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
Connecting a computer
An analog RGB (15 pin) computer cable can be connected.
TV back view
Computer
Audio cable for PC-
to-TV connection
Conversion adapter
(if necessary)
RGB PC cable
Mini D-sub 15 pin
Connect a PC cable from the computer to the RGB/PC
terminal on the back of the TV.
The following signals can be displayed:
VGA: VESA 640 x 480 @ 60/72/75 Hz
SVGA: VESA 800 x 600 @ 60/72/75 Hz
XGA: VESA 1024 x 768 @ 60/70/75 Hz
W-XGA: VESA 1280 x 768 @ 60/75 Hz
W-XGA: VESA 1360 x 768 @ 60 Hz
S-XGA: VESA 1280 x 1024 @ 60/75 Hz (Compressed)
However, these signal formats are converted to match the
number of pixels of the LCD panel.
Therefore, the TV may not display small text properly.
If you connect this unit to your PC, the compressed image is
displayed in S-XGA mode, therefore the picture quality may
deteriorate and characters may not be read.
Notes:
Some PC models cannot be connected to this TV.
•
•
•
•
•
•
•
Connecting an HDMI device
One HDMI cable (type A connector)
VIDEO AUDIO
L R
IN
OUT
HDMI OUT
HDMI device
TV back view
For proper operation, it is recommended that you use a short
HDMI cable.
HDMI cable transfers both video and audio.
Note:
It is possible that some HDMI device may not operate properly
with this TV.
Connecting a DVI device
One HDMI (type A connector)-to-DVI adapter cable and
audio cables
VIDEO AUDIO
L R
IN
OUT
DVI
OUT
DVI device
TV back view