TANDBERG Gatekeeper/Border Controller API D14172.01 - Manual (Page 52)

TANDBERG Gatekeeper/Border Controller API User Guide
D14172.01 page 52 of 84
RegistrationSerialNumber: <S: 0, 255>
The serial number of the registration to be removed.
SubZoneAdd
Adds and configures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
Address1: <S: 0, 39>
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength1: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address2: <S: 0, 39>
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength2: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address3: <S: 0, 39>
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength3: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address4: <S: 0, 39>
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength4: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address5: <S: 0, 39>
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength5: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
TotalMode: <None/Limited/Unlimited>
Determines whether this subzone has a limit on the total bandwidth of calls being used
by its endpoints at any one time.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if Mode is set to
Limited).
PerCallInterMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call to or from an
endpoint in this subzone.
PerCallInter: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this
subzone (applies only if Mode is set to Limited).