Troy-Bilt Electric Snow Thrower Flurry 1400 - Manual (Page 13)

Maintenance & Adjustments
6
13
Resetting Circuit Breaker
This snow thrower is equipped with a circuit breaker to prevent
overheating damage to the motor.
If the circuit breaker reset button pops out:
1.
Release the motor control lever and do NOT restart the
snow thrower for at least one minute, allowing the electric
motor time to cool.
2. Press the circuit breaker reset button (located on the switch
assembly) inward to reset. See Fig. 6-1.
Maintenance
Lubrication
Lubricate the pivot points on the motor control lever with a light
oil once every season and before the snow thrower is put into
storage at the end of the season.
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow
the instructions below.
•
Clean and lubricate snow thrower thoroughly as described
in the lubrication instructions.
• We do not recommend the use of a pressure washer or
garden hose to clean your unit.
• Make certain the power supply is disconnected.
• Store snow thrower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
• Wipe extension cord to remove any foreign substance such
as oil or stains. Replace extension cord if cut or damaged in
any way.
• Wind cord in a series of equal loops on each side of your
hand to prevent snarling.
Figure 6-1