Troy-Bilt Electric Snow Thrower Flurry 1400 - Manual (Page 8)

8 S
ection
2— A
SSembly
& S
et
-U
p
3. Ensure that the cord retainer is on the mid handle’s
crossbar. Refer to Fig. 3-2.
4. Place the mid and upper handles onto the lower handle.
See Fig. 3-4.
5. Insert wing knobs and carriage bolt and tighten to secure
upper handle and mid handle to the lower handle. See Fig.
3-4.
6. Secure motor cord to cable guide. See Fig. 3-5.
NOTE: The motor cord runs behind the upper handle.
Chute Assembly
1. Remove the four screws securing the front cover to the
auger housing. Remove the front cover and the chute. See
Fig. 3-6.
2. Remove the wing knob, bell washer and bolt from the left
side of the chute. See Fig. 3-7.
3. Pivot the upper chute upwards and over the lip and the top
of the lower chute.
4. Reinstall the wing knob, bell washer and bolt.
NOTE: When installing the bell washer the concave (or
cupped) side of the washer must be installed facing the in
towards the chute.
Carriage Bolt
Carriage Bolt
Handle Knobs
Figure 3-4
Cable Guide
Motor Cord
Figure 3-5
Screw
Front Cover
Chute Assembly
Figure 3-6
Figure 3-7