Tanita HD-339 - Manual (Page 6)

6
Setting (resetting) Calendar and Time
1. Set month
Press and hold the Up / button for two seconds to turn on the unit. Press
the Up / Down buttons to set month and then press the SET button. The unit
will beep once to confirm.
2. Set day
Press the Up / Down buttons to set day and then press the SET button.
The unit will beep once to confirm.
3. Set year
Press the Up / Down buttons to set year and then press the SET button.
The unit will beep once to confirm.
4. Set hour
Press the Up / Down buttons to set hour and then press the SET button.
The unit will beep once to confirm. Please be sure to set AM/PM correctly.
5. Set minute
Press the Up / Down buttons to set minute and then press the SET button.
The unit will beep twice to confirm and will flash all data to confirm the
program. The power will then shut down automatically.
NOTE:
• After you replace the lithium batteries, press and hold the Up / button
to begin the Calendar and Time programming process. Replacing the
batteries will cause the loss of Calendar and Time settings.
• Thirty seconds or more of inactivity will cause automatic shut off during this
process. No data will be saved as a result.
• If you make a mistake or wish to turn the unit off before you complete the
programming, press and hold the “1/OFF” button for three seconds or more
to turn the unit off. No data will be saved as a result.
Setting (resetting) personal data in memory
The unit can be operated only if data has been programmed into one of the
personal data memories.
Place your scale on a flat, even floor. You will need to measure your
current weight during this process.
1. Turn on the power
Press SET button to turn on the unit. The unit will beep to confirm activation.
The personal key number will flash.
• If Calendar and Time are not programmed the scale automatically enters
Calendar and Time setting mode. Please follow the instructions above.