Tanita HD-339 - Manual (Page 4)

4
Inserting/Replacing the batteries
The battery box is located on the back of the measuring platform.
Two 3-volt CR2032 replaceable lithium batteries
Lithium batteries can typically be used for many years
before replacement is necessary. When the low battery
sign, “LO” appears on the LCD, please replace with two
new lithium batteries.
Gently remove the battery cover. Press on the edge
of the battery to lift and remove the old batteries. Place
new batteries positive (+) side up being sure that they
are placed under the outer edge, as shown. Replace
battery box cover. Please program the calendar and time.
Weight Mode Switch
Select your preferred weight mode using the weight mode switch
located on the rear of the scale.
Positioning the unit
Place the measuring platform on a hard, flat surface where there is minimal
vibration to ensure safe and accurate measurement.
NOTE: To avoid possible injury, do not step on the edge of the platform.
Handling tips
• Do not attempt to disassemble the unit.
• Store the unit horizontally, and place it so that the buttons will not be
pressed accidentally.
• Avoid excessive impact or vibration to the unit.
• Place the unit in an area free from direct sunlight, heating equipment, high
humidity, or extreme temperature change.
• Never submerge the scale in water or spill chemical liquids on it. To clean,
use a dampened cloth and mild detergent.
• Do not drop any objects onto the platform.
KG LB