Sony KDL-52X2000 - Manual (Page 22)

22 GB
Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead (page 43)
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 7)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment (page 42)
Press
/ repeatedly until the correct input
symbol (see below) appears on the screen.
Additional operations
To use the Tools menu
Press TOOLS to display the following options when
viewing pictures from connected equipment other
than a PC.
* This option appears only if “i Speaker Link” is set to
“Off” (page 32).
On screen
display Labels of input jacks
AV1/2/3 or
AV1/2/3
1/2/3 or
1/2/3
AV4 4 (Y, P B /C B , P R /C R ) and
4 (L, R)
AV5 HDMI IN 5
AV6 HDMI IN 6
HDMI IN 6 and HDMI IN 6
(L, R)
AV7,
AV7 or
AV7
7,
7 (Y, P B /C B , P R /C R ) or
7, and
7 (L (MONO), R)
PC PC and PC
To Do this
Return to normal
TV mode Press DIGITAL or ANALOG.
Access the Input
signal index table
(except for PC video
input signal) Press to access the Input signal
index table. (Then, only in
analogue mode, press
g
.) To
select an input source, press
F
/
f
,
then press .
Options Description
Close Closes the Tools menu.
PAP (or Single Picture) See page 18.
Picture Mode See page 24.
Sound Mode See page 27.
Power Saving See page 31.
Sleep Timer See page 31.
i Volume* See page 32.
Auto Clock Set Allows you to switch to digital
mode and obtain the time.