TANDBERG 6000MXP - Manual (Page 91)

91
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
ISDN ParallelDial: <On/Off>
When set to On, channels will be dialed and connected in parallel when setting up a BONDING call.
When set to Off, channels will be dialled one by one, which may increase the dialling time.
Example: xconfiguration isdn paralleldial: on
ISDN HLC: <On/Off>
Turns sending of HLC information element in setup message on or off (video calls only). When HLC (Higher Level Capability) is set to On the system will signal, type of call i.e.
video call, telephony or data. HLC must be set to on to work with some PRIs in Italy.
Example: xconfiguration isdn hlc: on
ISDN SpeechTimers: <On/Off>
ISDN Layer 3, telephony calls. When set to Off, there will be no T310, T304, T301
Example: xconfiguration isdn speechtimers: on
ISDN MSN: <On/Off>
The use of MSN (Multiple Subscriber Number) enables you to attach different ISDN terminals, with different numbers, to the same physical ISDN telephone line.
If MSN is set to On only calls to numbers specified for the specific ISDN interfaces will be answered. This service can be ordered from your telephone company.
Example: xconfiguration isdn msn: on
ISDN SubAddress: <S: 0, 20>
Using a sub address enables you to connect up to eight ISDN terminals to the same ISDN telephone number and line. The terminals are addressed by using different sub ad-
dresses. To call a terminal with a sub address, separate the ISDN telephone number and the sub address with a
* . Note that this service has limited access on some ISDN
networks.
Example: xconfiguration isdn subaddress: 15
ISDN PRI NSFTelephony Mode: <On/Off>
Enables/disables use of NSF for telephony. NSF = Network Service Facility
Example: xconfiguration isdn pri nsftelephony mode: on
ISDN
cont...