Teac X-01 - Manual (Page 15)

15
ENGLISH
Repeat mode
< Halting playback stops the repeat mode.
< This feature is not available for all discs.
< The following buttons cancel repeat mode:
STOP, OPEN/CLOSE, POWER.
Track repeat
When this is selected, the currently-selected track repeats. If
another track is selected during repeat playback, the newly-
selected track repeats.
Disc repeat
The whole contents of the disc are repeated.
Programmed repeat
If programmed playback has been set up, the whole program
is repeated.
Pushing the REPEAT button cycles between REPEAT PGM
(program repeat) and REPEAT OFF (programmed playback
takes place).
Use the REPEAT button to select the repeat mode for
playback. Repeated presses of the REPEAT button cycle
between the following options:
REPEAT TRK
(track repeat)
REPEAT DSC
(whole disc repeat)
REPEAT OFF
(no repeat)
Display dimming
The display on the main unit can be dimmed to suit the
environment in which you listen to music. There are three levels
and an “off” setting.
Use the FL DIMMER button to cycle between these
settings.
Note that the OFF setting is not memorized when the power is
turned off. When the unit is switched off with the display off,
and then turned on again, the display is reset to the minimum
brightness.
Analog sound output
When playback is stopped, use the 2CH/MULTI button to select
either 2CH (stereo) or MULTI (multi-channel surround) audio
output from the analog outputs.
Note that if multi-channel program material is played and 2-
channel mode is selected, the multi-channel material will be
downmixed to two channels, and output through the L and R
front outputs.
< This setting is also reflected on the setup menu.
< 5.1CH indicator lights when “Multi ch” is selected.